PRO-TYP I I
Test adapter for electric charging stations (single/3-phase, type 2) for PROFITEST
Single and 3-phase test adapter with type 2 plug for testing the effectiveness of protective measures at electric charging stations with the Profitest Master, simulation of fictitiously connected electric vehicles and current-carrying capacity of cord sets per IEC 61851-1
- Vehicle simulation (CP)
Vehicle states A through E are selected with a rotary switch. - Cable simulation (PP)
The various codings for charging cables with 13, 20, 32 and 63 A, as well as “no cable connected”, can be simulated with the help of a rotary switch. - Fault simulation
simulation of a short-circuit between CP and PE by means of a rotary switch - Indication of phase voltages via LEDs
Depending on the charging station, either one or three phases can be active. - Testing of electric charging stations with permanently attached charging cable by means of an extended CP test pin
For vehicle simulation (CP)
States A, B, C, D and E can be simulated in accordance with IEC 61851. The various vehicle states are selected by means of a rotary switch.
- State A – no vehicle connected
- State B – vehicle connected, but not ready for charging
- State C – vehicle connected and ready for charging, venting of the charging area not required
- State D – vehicle connected and ready for charging, venting of the charging area required
- State E – error: Short circuit between CP and PE via internal diode
Regarding cable simulation (PP):
The various codings for charging cables with 13, 20, 32 and 63 A can be simulated. It’s also possible to simulate the “no cable” state.
The various charging cables are simulated by connecting different resistances between PP and PE with the help of a rotary switch. The following values are possible in accordance with IEC 61851:
- No cable – 0 Ω
- 13 A cable – 1.5 kΩ
- 20 A cable – 680 Ω
- 32 A cable – 220 Ω
- 63 A cable – 100 Ω
1 PRO-TYP II test adapter
1 set operating instructions
